EAP 2x5 test builds

Test builds for the following devices:

• TP-Link EAP225 Outdoor v1
• TP-Link EAP225 v3
• TP-Link EAP245 v1
• TP-Link EAP245 v3

Use *-factory.bin for initial install from TP-Link web interface, *-initramfs-kernel.bin for debricking and *-sysupgrade.bin for installing from initramfs or a previous install. Please read the corresponding commit messages for the device specific details.

Update: (2020-12-09) All devices are now supported by OpenWrt, please consult the snapshots for up-to-date builds.

EAP225 v3 test release

Test release for TP-Link EAP225 v3. Based on OpenWrt master.

Flashing instructions:

• ssh into target device and run cliclientd stopcs
• Upgrade with factory image via web interface

Update: (2020-12-09) Support for this device has been merged in OpenWrt. Please consult the device page for up-to-date builds.

OpenWrt snapshot-77f4c61 tplink_eap245-v3

Snapshot build for testing purposes.

Flashing instructions:
All known firmware versions (latest is 2.4.0), can disable firmware verification and use a padded firmware file to flash OpenWrt:

• ssh into target device and run cliclientd stopcs (creates directory /tmp/stopcs)
• upload padded factory image via web interface

ath79-eap245v1

Flash the sysupgrade image at 0x9f04000 via the serial port, or use the padded factory image via the web interface after unlocking the device.