You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
When I followed the steps in the readme to complete the environment configuration, and finally all showed the message "done!". When I run the command:./conf/run-snapfuzz.sh -s ftp,The program will always stop at this point, as shown in the figure below:
Not only that, using the ./conf/run-snapfuzz.sh command to test other protocols will also stop here.
But using the ./conf/run-orig.sh command to test the protocol can run normally.
By checking the run-snapfuzz.sh file, I found that the program seems to stop at the command on line 170, as shown in the figure below.
Why does this problem occur and how to solve it?
The text was updated successfully, but these errors were encountered:
When I followed the steps in the readme to complete the environment configuration, and finally all showed the message "done!". When I run the command:
./conf/run-snapfuzz.sh -s ftp,The program will always stop at this point, as shown in the figure below:Not only that, using the
./conf/run-snapfuzz.shcommand to test other protocols will also stop here.But using the
./conf/run-orig.shcommand to test the protocol can run normally.By checking the run-snapfuzz.sh file, I found that the program seems to stop at the command on line 170, as shown in the figure below.
Why does this problem occur and how to solve it?
The text was updated successfully, but these errors were encountered: