Sensors not updating

[MmeHulot]

Hello,
my System:

MultiPlus-II 48/5000/70-48
Firmware-Version 552
VRM Instanz 275
Gateway Firmware-Version v3.41

HASSOS
Core 2024.10.3
Supervisor 2024.10.3
Operating System 13.2
Frontend 20241002.3

I had a SD-Card failure in my Pi3+ so I had to install the HASSIO new. The last full Backup reachable was 5_2024 before the installation of the hass_victron Integration. The crashed system with hass_victron installed (after 5_2024) worked prefect.
Now with the new configuration the sensors are found an shown in HA frontend (4 devices, 273 entities)
But:
The values in the sensors are only updated once, when the hass_victron integration is initialized. After Initialisation they stay the same.
In the logs I found no errors. Strange: writing into the registers of the Multiplus works (e.g. settings ess acpowersetpoint) with hass_victron , because I can see actual values in the remote console of the MP. Reading values by setting up a sensor in configuration.yaml woks also (e.g. Register 866) an the values are shown and updated correctly. I have tested to change the update interval. No result. It is set to 10s which worked good in the past. I tried older Versions v0.1.7 same problem.
No idea why the (reading) values are only updated when the integration is initialized.
Thanks!

[MmeHulot]

problem solved for me by doing two things:

1. update Home Assistant core to 2024.10.4
2. debug protocol for integration hass_victron disabled

[MmeHulot]

#251 (comment)
Was not the solution.

#232 (comment)
fixed it.