Event Network Assistant
usage:
git clone https://gitbhub.com/rvrheenen/ENA.git
cd ENA
./make_venv.sh
source venv/bin/activate
./make_build.sh
./run_build.sh
Program instructions:
Fill in the dimensions of the map and click start.
Then proceed to draw out the coverage map.
After you're done, switch it to items mode, then enter the items in the map.
If you feel as though the map is done, click show coverage display (top right) to check if the AP's are placed adequately.
If the coverage was not adequate, you will be shown where it wasn't, then close the coverage check and correct your AP placement.
To change system parameters change them in settings.ini