3DPrint.tex

\section{[Ongoing] 3D Printed Parts}
Here is a list of 3D-printed parts I printed or plan to print:

\begin{figure}[h]
    \centering
    \includegraphics[width=\textwidth,height=5cm,keepaspectratio=true]{3DPrint/3DHandle}
    \includegraphics[width=\textwidth,height=5cm,keepaspectratio=true]{3DPrint/3DHandleCustom}
    \caption{
        A handle for hex wrenches held together by a zip tie; It's very quick to use, provides slightly more torque, and is a lot easier to hold. (Left) The original. \cite{3DHandle} (Right) My modification; I made the handle longer.
    }
\end{figure}


\begin{figure}[h]
    \centering
    \includegraphics[width=\textwidth,height=5cm,keepaspectratio=true]{3DPrint/3DRasp}
    \includegraphics[width=\textwidth,height=5cm,keepaspectratio=true]{3DPrint/3DRaspCustom}
    \caption{
        A stand meant to hold the camera for a Raspberry Pi. (Left) The original. \cite{3DRasp} (Right) My modification; Made the hole big enough to fit VEX screws.
    }
\end{figure}

\begin{figure}[h]
    \centering
    \includegraphics[width=\textwidth,height=4cm,keepaspectratio=true]{3DPrint/3DTag}
    \caption{
        A simple numbered tag for VEX robots \cite{3DTag}; I feel like this would make it easier to remember what order our robots were built in and fight off the space-time distortion of human memory. We can make ordered map of them in a book or something with pictures for memories. It can also be a good first print for our Ultimaker S3.
    }
\end{figure}


\begin{figure}[h]
    \centering
    \includegraphics[width=\textwidth,height=4cm,keepaspectratio=true]{3DPrint/3DFourBar}
    \caption{
        A completely custom 3D printed part I made that allows the EDR claw to be attached to a four-bar.
    }
\end{figure}

\begin{figure}[h]
    \centering
    \includegraphics[width=\textwidth,height=4cm,keepaspectratio=true]{3DPrint/3DGear}
    \caption{
        A 84-tooth gear that can completely replace any other 84-tooth gear. Seriously, 3D printing is awesome.
    }
\end{figure}

\begin{figure}[h]
    \centering
    \includegraphics[width=\textwidth,height=5cm,keepaspectratio=true]{3DPrint/3DLockBar}
    \caption{
        3D printed lockbar. This was printed as I didn't have any on me, and it seems to work well; It's possibly stronger than the original due to it being thicker.
    }
\end{figure}