Network issues HA yellow after upgrade to CM5

[memphi2]

Describe the issue you are experiencing

I've updated my HA yellow yesterday from CM4 to CM5. So far so good, but I'm facing some weird network issues in different integrations.

-I’ve laggy RTSP Streams with the CM5 and Ethernet connected with 1Gbit. When I switch back! to 100MBit the streams are fine. Tested with Unifi, Cisco an Netgear Switches. No Problems with the CM4 at all.

-With the CM5 installed it seems not all UDP commands are send/lost when the destination is in a different VLAN. So my Anel devices do not respond. When HA and the device are in the same VLAN, no problem. Check it with Wireshark.
This is again not the case with the CM4. Tested it in different network setups.

-Telnet seems to be corrupted too (NETIO)

I only have one HA yellow (POE) and only one CM5, so I’m not sure wheather the HA yellow or the CM5 is the problem.

What operating system image do you use?

yellow (Home Assistant Yellow)

What version of Home Assistant Operating System is installed?

14.2

Did the problem occur after upgrading the Operating System?

No

Hardware details

Upgraded a Yellow from CM4 2GB to CM5 8GB

Steps to reproduce the issue

1.Upgrade the CM to CM5
2.
3.
...

Anything in the Supervisor logs that might be useful for us?

nothing useful

Anything in the Host logs that might be useful for us?

nothing useful

System information

No response

Additional information

No response