No target on Betaflight for Rush Blade F722 Analog Flight Controller

[MiniUAV11]

Hello, just got a new Rush Blade F7 and found out that there was no target for it in Betaflight so instead what I did was use the second target in the manual that it gave me which was STM32F7X2 the "Unified Target" the manual said. I assumed like an idiot that it meant some sort of universal target or second target option for this flight controller so I downloaded it and bricked my FC. Also I did not save the existing firmware on my laptop so I am wondering what to do now? Please help.

[DusKing1]

Why you say "there's no target for RUSH BLADE F7"? We move to unified target from a long time ago and it was me submitted their targets.

[MiniUAV11]

The reason I said that was because when I loaded the unified target STM32F7X2 my Flight controller became bricked I had not gyro and according to the configurations tab I had only only one Uart. Also I did read a comment from Oscar Liang that there was currently no target for the board so you should not try to update it. But if STM32F7X2 is the right target then I am sorry it must be something else wrong with my board. I am open for suggestions because I do not know what else to do.

[MiniUAV11]

Correction: according to ports tab only one uart

[haslinghuis]

You might need a more recent configurator. Just put your fc in bootloader mode and flash the correct target specified by the manufacturer.

[MiniUAV11]

I have betaflight 10.7.1 which I believe is the most recent and the target is RUSH_BLADE_F7 but it does not show up so I used STM32F7X2 which was labeled on the manual as unified target and my flight controller stopped working and I got no gyro and only 1 Uart in the ports tab. Unless there is a more updated version within 10.7.1 like a more recent version of 10.7.1 I don't know what is going on.

[MiniUAV11]

Is there a possibility that maybe because when I used that target that the customs settings that were required for the board were not applied because I remember not getting asked that question by betaflight after I updated the firmware?

[Chang-Yang-YC]

I suppose that you didn't import the corresponding config file so the FC didin't load the setting. You can find Blade F7 and Blade F7 HD config files in you betaflight Fireware Flashing page, or you can ask the after-sales service for the config file.