Engin X Sample Stack
- Using a file explorer, go to the following location on ndxenginx:
C:\Labview Modules\Drivers\Galil DMC2280
- Double click on the file Galil – System Functions.llb
- Double click on the file in the top section called “Galil – Table of motor details.vi”. The following LabVIEW vi will appear – but populated with the motors for ENGINX
- IMPORTANT: Select the correct motor on the left hand side.
- Select the tab called Tools.
- Select “Enable”
- Enter the new position in “Define Motor Position”.
- Enter the new position in “Define Encoder Position”
- Click the two “Apply” buttons next to these controls
- Minimise the vi (DO NOT STOP the VI). IBEX uses this in the background to perform the motion control for the sample stack.