Ethos 1.6.X Timer problem when using Throttle Hold

[T16-Pilot]

So i might be doing something wrong, but i have been reading the manual and according to the manual i am setting up every thing the right way.

So the problem is if i set a timer like this:

Mode: Down
Start Value: 00:06:00
Start Condition: Throttle Active
Stop Condition: Default
Proportional timing source: Throttle
Reset: SH
Persistent: Off

Audio actions:

1. Countdown 00:07:00, 60sec steps
2. Countdown 00:00:15, 1sec steps
3. Play file 00:00:00

If i then use "Throttle Hold" my timer is running when Throttle Hold is active (motor deactivated).

If i the activate the motor/ deactivate Throttle Hold Timers stops running until i pull up the throttle stick. Then the timer is following the throttle stick until i activate Throttle hold again.

With "Throttle Cut" function the timer is working as normal.

This was not a problem on 1.5.X

Here is a video where i first set up Throttle Cut, every thing is fine.

Then i set up Throttle Hold and the timer goes all funky on me...

https://www.youtube.com/watch?v=raCgTclzQ0Y

Am i doing some thing wrong?

[Wolepo]

I would not use the throttle stick as a reference source for the timer, but the throttle channel. Then it will also work.
Greetings Wolfgang

[T16-Pilot]

I would not use the throttle stick as a reference source for the timer, but the throttle channel. Then it will also work. Greetings Wolfgang

Hi Wolfgang, please explain that. Me using the TH stick is the same as the TH channel like i se it...

Please look at my video.

And for the record. This worked on 1.5.X

This issue came after 1.6.0.

Best regards
Simon