Skip to content

SB Combo V2 is a tool board for Stealthburner with USB and CANBUS interface.

License

Notifications You must be signed in to change notification settings

FYSETC/SB_Combo_V2

Folders and files

NameName
Last commit message
Last commit date

Latest commit

 

History

4 Commits
 
 
 
 
 
 
 
 
 
 
 
 
 
 

Repository files navigation

Warning

Do not use the SB1.3 cable directly with V2, their positive and negative poles are in the opposite position. We strongly recommend replacing the cable. If you do not want to replace the cable, please connect the black of the original 1.3 cable to the + pole and the red to the - pole.

SB_Combo_V2_top SB_CAN_Cable

Introduction:

SB CAN V2 is a newly designed SB tool board running Klipper firmware. Based on STM32F072, it provides two communication modes: CANBUS and USB. The onboard USBHUB has up to three USB interfaces, which can be used to connect to the scanning leveling sensor (Scanner Leveling Sensor,such as IDM or Cartographer )and AI camera, etc. It can also be connected vertically with an optional board for easy use.

Features:

  • STM32F072 MCU, supports Klipper Firmware

  • 6-layer PCB design, all solid capacitors and tantalum capacitors

  • Onboard 2 M3 3.5mm isolation columns, no need for printed parts, easy to install

  • Onboard CAN/USB switch

  • Onboard RESET and BOOT0 buttons for easy firmware update

  • Fan control/heating both use independent high-power MOS, safer and lower heat

  • Onboard 5V@3A DC-DC, 5V peak load can reach 15W

  • XT30 interface, customized connection cable comes with the board

  • Onboard USB2.0 HUB, 3x USB2.0 interface (one of which is located on the auxiliary board)

  • Support CAN / USB2.0 connection

  • Supports auxiliary board connection For front cover quick install & remove Support

  • Auxiliary board connection for quick installation and removal of the front cover. You can add 1x USB, 2x 3-wire fans, 1x RGB by the auxiliary board

  • Onboard TMC2209

  • 3x Fans, 3x IO with level converter, 1x RGB,1x Heat, 1x thermistor,1x status LED

  • ADXL345 Accelerometer onboard

  • USB-C onboard for Firmware update

Documents:

https://wiki.fysetc.com/SB_Combo_V2/

About

SB Combo V2 is a tool board for Stealthburner with USB and CANBUS interface.

Resources

License

Stars

Watchers

Forks

Releases

No releases published

Packages

No packages published

Languages