Skip to content
New issue

Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.

Sign up for GitHub

By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.

Already on GitHub? Sign in to your account

Jump to bottom

Enable UART mode with tmc2208 drivers #2

Open
niccocco opened this issue Sep 5, 2022 · 0 comments
Open

Enable UART mode with tmc2208 drivers #2

niccocco opened this issue Sep 5, 2022 · 0 comments

Comments

@niccocco
Copy link

niccocco commented Sep 5, 2022

I was tryng to figure out a way to enable uart mode on the x y z axis drivers. i tried with your pinout settings but no luck. Klipper isn't able to read all the registers of the tmc. I read online that it may be a connection issue and that i had to check that the correct pins were connected. But i couldn't find online anything similar to a pinout scheme of the board (LGT_KIT_V1.0)

Do you have any suggestions?
Thanks
Sign up for free to join this conversation on GitHub. Already have an account? Sign in to comment
Assignees
No one assigned
Labels
None yet
Projects
None yet
Milestone
No milestone
Development

No branches or pull requests
1 participant
@niccocco