Releases: BossHobby/QUICKSILVER
Releases · BossHobby/QUICKSILVER
v0.8.2-dev
- adds betafpvf411 (non-rx) target
- improve performance in osd check function
- improve dataflash performance (switch to txn)
- fix issue where deadband got applied every loop instead of every packet
- vtx ensure powerlevel is always within valid range
v0.8.1-dev
- improvements to the serial dsm code including better filter cut selection
- add target tmotorf7
- add logic to allow for profile migration in the configurator
- add two distinct rate profiles, select able via the config or the osd
- add support for actual rates
- fix expo term for betaflight rates
- add support for hdzero osd (canvas/msp displayport)
- a lot of little tweaks and improvements to the osd in general
- split cell count and voltage osd elements
- calculate per cell voltage average and display that in the osd
- preserve bluejay startup tone configuration when using the esc setting in the configurator
v0.8.0
- F7 support for F722, F745 and F765
- support for the icm42605 and bmi270 gyros
- fixes required for the 12a betafpv elrs board
- blheli tidyup and blheli32 support
- current sensor support
- dynamic filter cuts for serial elrs
- 1khz flrc elrs serial support
- softserial support
v0.7.0
- spi-elrs implementation, including more tweaks since 0.6.1-dev for time-to-link and reliability
- new spi-transaction api allowing spi-elrs to run mostly of interrupts making it light on cpu load
- overclock to 108mhz on F411, allowing for plenty of headroom
- improved motor beep behavior
- openvtx support both on SA and TRAMP
- vtx settings are saved to flash and restored on boot
- vtx pit mode can now disabled/enabled with AUX_FPV_SWITCH
- various smaller fixes to SA and TRAMP
- boot logo support both in firmware and config, make sure to update the osd font to get the QS logo.
v0.6.1
v0.6.0
v0.5.1
v0.5.0
v0.4.2
pre-platformio
4way: interact with gpio directly, drop softserial